[email protected] Flite Models Champaign, ILPh: (217) 398-8970, Ext. 5Fax: (217) 398-7721READ THROUGH THIS MANUAL BEFORE STARTING CONSTRUCT
2INTRODUCTIONTop Flite is very proud to bring you the giant scale Zero. The Zero became one of the most important fi ghters of World War II. You will e
3the head of the screw in the hole and then glue the doubler to the former. Repeat this for the other screw and doubler.❏ 4. Once assembled the former
4Release PinTemplate❏ 7. If you are using the servo we used, Futaba S3102, the instructions for the release pin that follows will be correct for this
5ASSEMBLE THE DROP TANK❏ 1. Locate the parts shown here. Glue the two plywood plates together. Use the two wood dowels to align the two plates when gl
6❏ 6. With the fi ber drop tank retainer in place on the release pin, slide the top half of the drop tank onto the retainer. When positioning the tank
7❏ 11. On the bottom of the wing, under the covering, you will fi nd two pre-installed blind nuts and an access hole to feed the servo lead through the
Kommentare zu diesen Handbüchern